Did I not read something about VAC cable 1 and 2 reversing in the latest version of PSDR..?

73...VE6ZT

----- Original Message ----- From: "Bernie Huth" <[email protected]>
To: <[email protected]>
Sent: Wednesday, September 05, 2012 12:03 PM
Subject: [Flexradio] CW Skimmer with PowerSDR v2.4.4


I am not able to get CW Skimmer v 1.71 to decode properly with PowerSDR
v2.4.4 and a Flex-3000.

The radio CAT commands seem to be working correctly using PowerSDR v2.4.4
and DXLabs Commander.  CW Skimmer is setup as a secondary CAT control in
Commander using Kenwood CAT protocol. The correct frequency is indicated in
both Commander and CW Skimmer.

There is noise indicated in the CW-Skimmer waterfall, however, there is no
CW decoding indicated. The Audio setup in CW Skimmer is:

SoundCard Driver: WDM
Signal I/O Device: 04 Virtual Cable 2
Audio I/O Device: 03 Virtual Cable 1
Channels: Left/Right: I/Q
Shift Right Channel Data: 0 Samples

The Radio setup in CW Skimmer is:

Hardware Type: SoftRock IF
CW Pitch: 750 Hz
Audio IF: 9750 Hz
Sample Rate: 96 kHz

The PowerSDR v2.4.4 VAC setup is:

Primary:
 Buffer Size: 1024
 Sample Rate: 96000

VAC1:
 Enable VAC1... Checked
 Driver: Windows WDM-KS
 Input: Virtual Cable 1
 Output: Virtual Cable 2
 Buffer Size: 1024
 Sample Rate: 96000 Hz
 Mono/Stereo: unchecked
 Direct I/Q: checked
 Calibrate I/Q: checked
 Buffer Latency: 120
 Allow PTT to override... checked

Any ideas?

-73-
Bernie
W4BGH
Riverview, FL
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/


_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/  Homepage: http://www.flexradio.com/

Reply via email to