Am Thursday 27 October 2005 16:55 schrieb Curtis L. Olson: > Oliver Schroeder wrote: > >Hi list. > > > >I just stumbled over the jpeg-factory again. Simgear defaults to build > > with jpeg factory enabled, while flightgear defaults to build without it. > > So one either has to supply "--without-jpeg-factory" to simgears > > configure or "--with-jpeg-factory" to flightgears. > >This should be harmonised. I experienced it under Linux and didn't look > > into it. Maybe the defaults are correctly set under other environments. > > I believe the defaults are correctly set to both build without, but once > you build and install simgear with it, the header file is installed so > flightgear autodetects it. If you later build simgear without, that > header file will still be installed and flightgear gets confused. You > just need to remove the installed simgear header file for jpeg factory > and you should be good from that point on.
Your are right. Deleting the header file solved this problem. Just for the record, it's $(INLCUDEDIR)/simgear/screen/jpgfactory.hxx regards, Oliver _______________________________________________ Flightgear-devel mailing list [email protected] http://mail.flightgear.org/mailman/listinfo/flightgear-devel 2f585eeea02e2c79d7b1d8c4963bae2d
