Hi, sorry, this is perhaps a little bit off topic but I haven't found any answers the last days:
How can I start up at a specific position in air? I found some hints at http://wiki.flightgear.org/index.php/Starting_in_the_Air but if I use the SenecaII I have the problem that the magnetos are off, the nose of the plane is turned down to earth and the simulation is in running state. I tried the following: fgfs \ --altitude=5000 \ --heading=270 \ --vc=110 \ --vor=OAK \ --offset-distance=5 \ --offset-azimuth=270 \ --aircraft=SenecaII-jsbsim \ --prop:/controls/engines/engine/throttle=0.8 \ --prop:/controls/engines/engine/magneto=true \ --prop:/controls/engines/engine/magneto[0]=true \ --prop:/controls/engines/engine[0]/magneto=true \ --prop:/controls/engines/engine[1]/magneto=true \ --prop:/controls/engines/engine[0]/magneto[0]=true \ --prop:/controls/engines/engine[1]/magneto[0]=true \ --prop:/controls/engines/engine[0]/starter=true \ --prop:/controls/engines/engine[1]/starter=true \ --enable-freeze \ --geometry=170x100 I need this for learning landings and ILS approaches towards an airport. For this it would be nice when the simulations starts at a well trimmed point... Has anyone an idea how to get this running? Thanks, Holger -- ##### #### ## ## Holger Wirtz Phone : (+49 30) 884299-40 ## ## ## ### ## DFN-Verein Fax : (+49 30) 884299-70 ## ## #### ###### Stresemannstr. 78 E-Mail: [EMAIL PROTECTED] ## ## ## ## ### 10963 Berlin ##### ## ## ## GERMANY WWW : http://www.dfn.de GPG-Fingerprint: ABFA 1F51 DD8D 503C 85DC 0C51 E961 79E2 6685 9BCF ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Flightgear-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/flightgear-devel
