Comments below... > -----Original Message----- > From: swordfish667 [mailto:[EMAIL PROTECTED] > Sent: April 24, 2006 18:54 > To: [email protected] > Subject: Unable to configure IDSM for traffic analysis > > > > hello guys > > i need some help in configuring the idsm2. I have configured > the 6509 switch > to capture network traffic using SPAN. i have mentioned vlan > as source, for > the source SPAN traffic. but after specifying the capture > destination on the > 6509 (a physical port on the 6509), i am confused about how > to send this > traffic from the captured port for analysis to virtual > sensing port on the > IDSM.Basically i am not able to map the phyical destination > port on the > switch to the virtual sensing ports. <SNIP>
Have you tried following the steps in the Installation guides? They vary depending on what version of the software you want to run on the IDSM-2. Cisco IDS v4.x (beware of line wraps): http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_installation_and_configuration_guide_chapter09186a008035809d.html#wp86441 Cisco IPS v5.x (beware of line wraps): http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_installation_guide_chapter09186a008055fc73.html#wp712919 I hope this helps, Alex Arndt, CD CISSP, GCIA, GCIH ------------------------------------------------------------------------ Test Your IDS Is your IDS deployed correctly? Find out quickly and easily by testing it with real-world attacks from CORE IMPACT. Go to http://www.securityfocus.com/sponsor/CoreSecurity_focus-ids_040708 to learn more. ------------------------------------------------------------------------
