This message is from the T13 list server.
Here are some documents from the T10 (SCSI) web site which describe the CDB
interface to SCSI and ATAPI disk drives.
There are other related and required documents there, as well.
------------------------
SCSI-3 Block Commands (SBC)
http://www.t10.org/ftp/t10/drafts/sbc/sbc-r08c.pdf
{Date: 1997/11/13, Rev: 08c, Status: Published, Project: 0996-M, File:
sbc-r08c.pdf (796576 bytes)}
SBC describes the command sets for block-oriented direct-access devices
such as magnetic disk drives.
The above link retrieves the final T10 committee draft. Please contact ANSI
(+1-212-642-4900) and ask for NCITS.306:1998 to purchase the official
standard or technical report. You can also
search for this document on the INCITS Standards Store. All T10 standards
are available there for $18.00 in PDF format.
-------------------------------------------
SCSI Block Commands - 2 (SBC-2)
http://www.t10.org/ftp/t10/drafts/sbc2/sbc2r10.pdf
{Date: 2003/09/13, Rev: 10, Status: Development, Project: 1417-D, File:
sbc2r10.pdf (1162888 bytes)}
SBC-2 describes the second-generation command sets for block-oriented
direct-access devices such as magnetic disk drives.
------------------------------------------------------
Thank You !!!
-----------------------------------------------------------------
Jim Hatfield
ATA Interface Firmware & T13 (ATA/ATAPI) Standards Representative
Seagate Technology - PSG
e-mail: [EMAIL PROTECTED]
s-mail: 389 Disc Drive; Longmont, CO 80503 USA
voice: 720-684-2120
fax : 720-684-2711
====================================================
|---------+---------------------------->
| | Matthias F�gger |
| | <[EMAIL PROTECTED]|
| | > |
| | Sent by: |
| | [EMAIL PROTECTED]|
| | rg |
| | No Phone Info |
| | Available |
| | |
| | 10/27/2003 01:01 |
| | PM |
| | |
|---------+---------------------------->
>-------------------------------------------------------------------------------------------------------------------------------|
|
|
| To: <[EMAIL PROTECTED]>
|
| cc:
|
| Subject: [t13] specification of PACKET opcodes
|
>-------------------------------------------------------------------------------------------------------------------------------|
This message is from the T13 list server.
Dear all,
Is there a PACKET command opcode for a harddisk implementing the PACKET
command feature set, which allows me to write to the disk (e.g. sector
by sector) similar to the WRITE SECTOR(S) command for older devices? If
yes, where is it specified (I could only get information on the PACKET
command in general, but not on the PACKET command opcodes from the
current ATA/ATAPI 6 specification)? If not, how do I write data to a
harddisk implementing ATA/ ATAPI 6?
Thank you in advance!
Yours sincerely,
Matthias Fuegger
