I was only referring to mirroring entities, not complete layers. You can get
into trouble if components are flipped.
Craig
--
Craig,
I am afraid this doesn't work. The pressing the X or Y buttons during the
Move|Selection command does not invert the layers it only inverts the
entities on the layer they already exist on.
<snip>
Disappointed,
Ian Wilson
>-----Original Message-----
>From: Robison Michael R CNIN [mailto:[EMAIL PROTECTED]]
>Sent: Wednesday, May 09, 2001 7:05 AM
>To: 'Protel EDA Forum'
>Subject: [PEDA] mirror layout
>
>
> [Robison Michael R CNIN] hello,
>
> i've been doing a series of small two-sided boards and i'm just
> going from an old pcb when i do the work, along with a drill hole
> spec.
>
> what i'm wondering is if i can flip the rear side when i'm laying
it
> out so that i don't have to mentally mirror it. i looked under
view
> in the menu and in the help utility but no luck.
>
> thank you, miker
>
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
