Eric
When you are creating your layers in the layer stack manage, pick 'add
layer' for your inner routing layer instead of 'add plane'. That's what I do
and it works fine. Hope this helps.
Susan
-----Original Message-----
From: Eric Albach [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, May 15, 2001 15:54
To: Protel EDA Forum
Subject: [PEDA] Traces on an internal plane
How can I route copper traces on an internal plane? I need to place many
copper traces on the internal ground plane and have only found normal split
planes or non-copper traces which would be a very difficult way to do it.
Thanks,
Eric
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
