Hi guys,
I have a goofy one that is really bugging me at the moment. I have
seen it before but not so bad and I just dealt with it under the
circumstances but now I want to understand what is happening.
I had a schematic design and basic component placement, then we
changed one part type in schematic (approx. 30 pieces). At the PCB level
this should have changed an 0603 cap to a 0402 cap. I used the synchronizer
to implement the changes to the placed PCB. The synchronizer changes listed
all the component footprint changes as expected. I ran the synchronization
and the land pattern footprint "fields" were changed, BUT the actual land
patterns did not change. I now have a bunch of 0603 cap land patterns which
list their footprint fields as 0402C. Yes I did have the "Update component
footprints" checkbox checked and the appropriate libraries were listed in
the DDB. I did not get any synchronizer errors listing "footprint not
found".
Now I have had to go into the components (in PCB) and globally edit
all these caps to a third land pattern and then change them back to the
desired land pattern. Why did the land patterns not change through the use
of the synchronizer?
Brad Velander,
Lead PCB Designer,
Norsat International Inc.,
#300 - 4401 Still Creek Dr.,
Burnaby, B.C., V5C 6G9.
Tel. (604) 292-9089 direct
Fax (604) 292-9010
website www.norsat.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
