Dave,
I normally don't use this feature but tested it after your message.
It definitely doesn't work properly. I could get '>' or '<' to work pretty
good as far as I could tell on my design. I could not get '=' to work at all
for any hole size. I also got '<>' to work on my design. So it does work to
a certain degree. Actually it seems anything utilizing any function other
than '=' works.
Brad Velander,
Lead PCB Designer,
Norsat International Inc.,
#300 - 4401 Still Creek Dr.,
Burnaby, B.C., V5C 6G9.
Tel. (604) 292-9089 direct
Fax (604) 292-9010
website www.norsat.com
> -----Original Message-----
> From: Dave Eloranta [mailto:[EMAIL PROTECTED]]
> Sent: Friday, June 01, 2001 2:40 PM
> To: 'Protel EDA Forum'
> Subject: [PEDA] Select hole size doesn't work with my protel98 SE SP6
> (old macro) (old addon)???
>
>
> I have had no success selecting a hole size with edit -
> select - hole size.
> I also have limited success placing a hole of a size then
> doing a edit -
> change - selection, match hole size.
> This has been the case for more than a year, and going back
> more than one
> release of protel.
> I've had this problem for several past versions of protel and
> I am guessing
> it is some out dated code lingering from a past version /
> service pack or
> macro that is causing the problem. I would think some one
> knows exactly the
> problem.
> Thank you
> Dave Eloranta
> [EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
