Hi > I have 2 Bigiron 4ks with Management 4(IronCore) acting as my distribution > layer switches. I have 2 Juniper M10s as my border routers. I have 1 transit > ISP on each border router. I want to run IBGP between all 4. Has anyone had > any bad experiences with putting the full table on the bigiron 4ks? They > both have 512 meg ram.
Until resently I had two complete ebgp connections and about 15 IBGP connections to router reflector clients. This was on a HP9304 which should just be a BigIron 4k OEM model. There was no problem with this. We are using S1: J4885A EP 8 port mini-GBIC Management M4, ACTIV 8 000c.db2f.4100 which should be JetCore module. So I dont know about IronCore. On a HP9315 we currently run --- SSH at comx>sh ip bgp sum BGP4 Summary Router ID: x.y.z.32 Local AS Number : 31661 Confederation Identifier : not configured Confederation Peers: Maximum Number of Paths Supported for Load Sharing : 1 Number of Neighbors Configured : 13, UP: 13 Number of Routes Installed : 336055 Number of Routes Advertising to All Neighbors : 2223776 Number of Attribute Entries Installed : 60644 Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend x.y.z.33 31661 ESTAB 31d14h38m 0 0 197301 16 x.y.z.34 31661 ESTAB 49d18h15m 0 0 197301 16 x.y.z.35 31661 ESTAB 57d10h46m 0 0 197301 16 x.y.z.37 31661 ESTAB 57d10h46m 140211 0 149293 13 x.y.z.38 31661 ESTAB 57d10h46m 0 0 197301 16 x.y.z.39 31661 ESTAB 14d 3h35m 0 0 197301 16 x.y.z.40 31661 ESTAB 57d10h46m 0 0 197301 16 x.y.z.41 31661 ESTAB 3d11h12m 0 0 197301 16 x.y.z.42 31661 ESTAB 51d23h31m 0 0 197301 16 x.y.z.43 31661 ESTAB 57d10h46m 0 0 197301 16 x.y.z.61 31661 ESTAB 57d10h46m 0 0 149293 13 x.y.z.62 31661 ESTAB 57d10h46m 7 0 149293 13 213.y.x.149 3356 ESTAB 1d17h27m 195833 0 5 0 which is one EBGP feed, one IBGP and about 10 IBGP route reflector clients. This also worksfine. --- Yours Per Marker Mortensen <per at markermortensen.dk>
