Hi!
I have gotten a very helpful mail from Kenneth Hellmann, which has
given me some information about upgrading the image without actually a
working image.
Unfortrunatly I have to wait until I get physical access to the
machine, as it is in this state at the moment, that it states
"Bootstrap stopped for sds go command". I presume that this is some
kind of keystroke to get the machine booting again. Anyway, I am sure,
the box need a cold restart.
Regards,
Matthias
Am 14.09.2008 um 16:57 schrieb david raistrick:
On Sun, 14 Sep 2008, Matthias Gelbhardt wrote:
I have a FESX424-PREM. Unfortunatly the firmware upgrade went
terribly wrong and so I do not have a working image in the primary
flash. I suppose that was
I assume it's not under support anymore? The support folks have
walked me through unbricking a serveriron a few times (different
situation, though. tftp'd a config that wouldn't boot)
Unfortunatly this image seems not to have any IP connectivity,
which I do not understand (any ip and bgp commands in the startup
config are not executed).
sounds like switch code instead of router code. different command
set to set an IP and default route. (which I don't have handy)
...david
---
david raistrick http://www.netmeister.org/news/learn2quote.html
[EMAIL PROTECTED] http://www.expita.com/nomime.html
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
