Chuck:
Just a couple of things to check. SX-FI424HF was supported starting 2.4.00. If you're running anything earlier than 2.4, I would suggest upgrading. Another possibility is that you have a IPv6 management module with an IPv4 line card (or vice-versa). Make sure it's an SX-FI12GM-4 and an SX-FI424HF card, or SX-FI12GM-6 and SX-FI624HF. You can't mix and match IPv4 and IPv6 cards. Another possibility is that the slot you're trying to use it in is bad. try a different slot in the chassis. The final possibility is that you have a defective card that needs replacing. Get in touch with TAC and get it swapped out. Good luck, Jared Valentine [email protected] _____ From: [email protected] [mailto:[email protected]] On Behalf Of Chuck Ufarley Sent: Thursday, June 25, 2009 10:42 AM To: [email protected] Subject: [f-nsp] SX-FI424HF not coming online Hey everybody-- You guys are always so consistently helpful, I thought I'd try this one out. I've got this SX-FI424HF I'm trying to bring up on an FI-SX-4 with an SX-F112GM-4-PREM management card, and the thing won't even come online (output below). I'm wondering if the mgmt card doesn't support the line card. Secondly, it doesn't say "HF" anywhere on the blade. Is there any way to confirm the HF status from the markings on the outside? Last (obviously), does anyone have any insight or advice on the ouput below? FastIron SuperX Router#M:6 L:0 - ERROR: i2c MUX select failed, MUX address = 74, channel = 5, offset = 0, status = -1 stack: 4080 5A15E4 5A4C50 B711D8 B7135C B71700 B86650 54B578 54C690 48B8 Error : System failed to detect all the devices on this module (1,2,1) Module 1 Init failed Err: Enabling module 1 Failed [1]Retrying .. Error : System failed to detect all the devices on this module (1,2,1) Module 1 Init failed Err: Enabling module 1 Failed [2]Retrying .. Error : System failed to detect all the devices on this module (1,2,1) Module 1 Init failed Err: Enabling module 1 Failed [3]Retrying .. Error : System failed to detect all the devices on this module (1,2,1) Module 1 Init failed Err: Enabling module 1 Failed Taking down module 1 ... Module 1 is now deleted Powering off the module in slot 1 Thanks in advance, everybody. Your insight is always appreciated. --Chuck
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
