Hi Eric and Dimitar,
I am planning on replacing the fiber strands and also the SFP modules,
on the slight chance there is something wrong with one of them.
As for the port configuration, they were all set to
no flow-control
gig-default neg-off
I am planning on putting that strand up on an empty port on my BI and
assign an IP to the interface with a server at the other end of the /30
so I can test the line to make sure everything is working. If I don't
see any packet loss then I will be moving the fiber to 1/8 and setting
up the trunk again.
Thanks for everything
Joe
Are all the ports configured identical to the primary ports? Make sure the ports are in the correct grouping?
----- Original Message ----
From: Dimitar Kostadinov <kgb at bginfo.net
<http://puck.nether.net/mailman/listinfo/foundry-nsp>>
To: foundry-nsp at puck.nether.net
<http://puck.nether.net/mailman/listinfo/foundry-nsp>
Sent: Thursday, July 9, 2009 1:59:32 AM
Subject: Re: [f-nsp] Trunking Problem
On Wed, 08 Jul 2009 19:38:28 -0400
May be one of Your fiber dont work good.
1. check one by one link BI-1/1 <=> FI-1/7 and BI-1/2 <=> FI-1/8
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
