Savvas, I am copying the instructions on configuring vlans and then date and code afterwards. untagged ethernetUse this command to assign ports as untagged members of a port-based VLAN. Use the ports from a port-based VLAN.no form to removeSyntax untagged ethernet no untagged ethernet interface [to interface]interface [to interface]• • interface - Specifies a port number, or the start or end of a port range, to assign to the VLAN.unit/port- - • unit - This is device 1.port - Port number.to - Specifies the end of a port number range.Default Setting None Command Mode VLAN Configuration ExampleThe following example shows how to assign switch ports 1 to 8 as untagged members of VLAN 222. tagged ethernetUse this command to assign ports as tagged members of a port-based VLAN. Use the from the port-based VLAN.no form to remove portsSyntax tagged ethernet no tagged ethernet interface [to interface]interface [to interface]• • interface - Specifies a port number, or the start or end of a port range, to assign to the VLAN.unit/port- - • unit - This is device 1.port - Port number.to - Specifies the end of a port number range.Default Setting Nonedual-modeUse this command to enable a tagged VLAN port to accept and transmit both tagged and untagged traffic. Use the no form to restore the default setting.Syntaxdual-mode [ no dual-mode • vlan_id]vlan_id - Specifies the default VLAN ID for the port. (Range: 1-4094, no leading zeroes).Default Setting Disabled Command UsageConfiguring a tagged port as a dual-mode port allows it to accept and transmit both tagged traffic and untagged traffic at the same time. A dual-mode port transmits only untagged traffic on its default VLAN (that is either VLAN 1, or a user specified VLAN ID), and only tagged traffic on all other VLANs.Command Mode Interface Configuration ExampleThe following example shows how to enable dual-mode on port 5 and set its default VLAN ID to 10.Console(config)#vlan 10 by port Console(config-vlan-10)#untagged ethernet 1/1 Console(config)#vlan 222 by port Console(config-vlan-222)#tagged ethernet 1/5 Console(config)#interface ethernet 1/5 Console(config-if)#dual-mode 10 Console(config-if)# 22421 3/24/2005 12:36:33 AM File Folder 22518 4/4/2005 7:04:42 PM File Folder … many in between 22732 4/21/2009 11:18:04 AM File Folder
Eric Hi, I have recently purchased a few Foundry EdgeIron EIF24G models. I am having some trouble using tagged vlans and the OS seems ancient, the configuration has been verified by multiple engineers now so I figured maybe a firmware upgrade should get me where I need to be. Is there anyone who can help me with recent software for these units? My sh ver output: Vty-0#sh ver Unit1 Serial number :AN00001310 Service tag : Hardware version :R01 Number of ports :24 Main power status :up Redundant power status :not present Agent(master) Unit id :1 Loader version :1.0.0.0 Boot rom version :1.0.0.1 Operation code version :2.0.1..9 Any help would be much appreciated. Thanks, Savvas _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
