* [email protected] (Remco Bressers) [Mon 10 May 2010, 16:04 CEST]:
I'm testing mpls vll-local on an MLX-4 and came to the conclusion
that VLAN tag translation between 2 ports using vll-local works
fine, but i cannot seem to do any local routing anymore by using ve
devices. Is this correct?
The config :
router mpls
vll-local testing123
vlan 4030
tag e 2/1
vlan 4031
tag e 2/2
Now, i CAN add the following :
vlan 4030
router-interface ve 4030
!
interface ve 4030
ip address 10.0.0.1/29
!
But this doesn't seem to do anything.
That's correct. There are no ports in VLAN 4030 (you can verify this
by doing "sh vlan 4030" and "sh vlan e 2/1" - note that the latter
will say that the port is a member of 0 VLANs).
There is a difference between a "VLAN" and a "L2 VLAN" in Foundry
parlance. I'm not sure which is which, but one is configured with
"conf t; vlan xyz; tagged e x/y; router-interface ve x" and the
other is used only as a number to fill out in the 802.1Q tag under
VPLS or VLL instances.
Is there anyone who can help me with this? Is there a different way
to do this?
Not that I'm aware of without running a cable back between two ports.
-- Niels.
--
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
