Hi George I'm really quite a newbie when it comes to MRP. RHP rcvd / sent = 8.22 (close to 8). Is that worth noting? If the ring ID was different on all 4 devices, not converging so sending out both interfaces, that would mean that each device should show 8 times(ish) the figure of what is sending out??
Packet captures might be the way to go, if we can find the protocol spec from foundry.. Heath On 11 September 2010 20:02, George B. <[email protected]> wrote: > See this diagram for reference: > > http://tinypic.com/r/kb93lj/7 > > This is pretty simple. I have one vlan in an MRP ring through 4 MLX > units. I configure the master, and it works as expected. I then configure > the members. The problem is when the last "member" (non-master) is > configured in the ring, the master begins to receive thousands of RHP and TC > RBPDUs per second. It doesn't matter which one is the last member > configured but as soon as I enable RHP on that last member, the count of RHP > and TC RBPDUs goes haywire. Here is what my master currently shows: > > RHPs sent RHPs rcvd TC RBPDUs rcvd > 509883 4193162 3684318 > > As you can see, it has sent about a half a million RHPs but received over 4 > million of them! > > Only one unit is configured as "master". As long as I have MRP > unconfigured on one of the members, the ring works as expected. There is no > spanning tree of any sort running on that vlan. I am just in awe of how RHP > packets can seemingly be created in the network somewhere at such an amazing > rate! > > Anyone else seen anything like this? It is just plain wacky! > > George > > > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
