A config example will help paint a clearer picture. If you want an interface to be "route only", then put it in the default VLAN and add an IP to it:
SSH@core01#show run int e 6/2 interface ethernet 6/2 port-name ussvl load-interval 30 ip address 172.30.253.249 255.255.255.252 ip ospf area 0.0.0.0 ip ospf priority 250 ipv6 address 2620:a4:1:fff0::1/64 ipv6 ospf area 0.0.0.5 ! On Thu, Mar 3, 2011 at 5:55 AM, <[email protected]> wrote: > Hello. > Every time i'm trying to disable "L2 Switching" or enable "Route Only" > or global or per port basis, i'm getting these options disabled again > after saving to flash and reloading of device (i'm running Base L3 layer > firmware on FES2404). > > I'm interesting in these options because i want to apply extended ACL > to one of ports on my device. > > I've also found that "ACL filtering based on VLAN membership or VE port > membership (acl-per-port-per-VLAN)" feature is not supported. Does this > mean that it's impossible to apply any ACL rule to the port that > actually is a member of non-default VLAN group? > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
