Try disabling icmp redirects globally and/or no ip redirect on ve's
On 3/30/12 5:51 PM, Adam Davenport wrote:
You can rconsole the MP (and/or LP's) and run the "debug packet
capture" command. This will show you packets hitting the CPU on the
module. The default output is 25 packets. Running a "show cpu lp"
will also show CPU usage on the individual LP's which may make it
easier to single out the source of the CPU increase.
Adam Davenport / [email protected]
On 3/30/2012 3:19 AM, Remco Bressers wrote:
Hi list,
We are running a few XMR's in our network where one of them is showing
increased CPU usage on ip_rx. The box is not doing enormous amounts of
traffic (<10Gig) and a similar configuration on a different part of the
network isn't showing any CPU usage problems.
What is the best way to debug CPU issues like this and how can i get a
better insight in the way an XMR uses CPU cycles? A "show cpu" and "show
tasks" shows me what i already know and now i find it very hard to
debug.
Any ideas?
Regards,
Remco Bressers
Signet BV
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
--
Jeroen Wunnink
Network Engineer
Atrato IP Networks
[email protected]
Phone: +31 20 82 00 623
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
