Are you looking for something like this? telnet@FCX(config)#show run | in community snmp-server community ..... ro snmp-server community ..... rw telnet@FCX(config)#enable password-display <<--- telnet@FCX(config)#show run | in community snmp-server community 1 $Sa2^Zd ro snmp-server community 1 $SUbr3o8 rw telnet@FCX(config)#
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Robert Hass Sent: Monday, August 06, 2012 12:37 PM To: [email protected] Subject: [f-nsp] Show SNMP community string configured on FastIron Hi Is any way to display currently configured community string on FastIron ? I cannot display them. There is also no command like 'no service password-encryption' It's ICX 6450 running FastIron software 7.4.00a. ICX6450-24 Router#show snmp server Contact: Location: Community(ro): ..... Traps Cold start: Enable Link up: Enable Link down: Enable Authentication: Enable MAC Authentication: Enable Locked address violation: Enable Power supply failure: Enable Fan failure: Enable Metro ring: Enable Module inserted: Enable Module removed: Enable Temperature warning: Enable STP new root: Enable STP topology change: Enable ospf: Enable bgp: Enable vrrp: Enable vrrpe: Enable vsrp: Enable Holddown time: 60 Total Trap-Receiver Entries: 0 ICX6450-24 Router#sh run | inc snmp snmp-server community ..... ro Rob _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
