Hi Erich, there was no other module in the slot.
At first the module was not regocnized so I set "module 4 ni-mlx-10gx4" manually but it didn't help. I had removed the module, delete the line out of the config and reinsterted the module. Now the mlx says "S4: Invalid Module CARD_STATE_REBOOT 0 000c.dbe1.2f90" instead of S4: Invalid Module CARD_STATE_REBOOT 0 xxx (S4: Configured as NI-MLX-10Gx4 4-port 10GbE Module). Thanks anyway for your hint, I'm still looking for the solution :-) Gunther -----Ursprüngliche Nachricht----- Von: Erich Hohermuth [mailto:[email protected]] Gesendet: Mittwoch, 24. Juli 2013 23:42 An: Gunther Stammwitz Cc: 'Niels Bakker'; [email protected] Betreff: Re: [f-nsp] NI-MLX-10Gx4 shown as "Invalid Module" maybe due to very old code on lp whlile chassis is on 5.3 Hi Gunther, Out of curiosity, cause I had a similar case. Was another LP in the same slot before ? Cause if you remove a card, the config is still in place and you have to remove the module in the config before you re-insert a different card. Regards Erich Am Wed Jul 24 23:28:49 2013 schrieb Gunther Stammwitz: > Hi Niels, > > upgrading boot+monitor+lp image is exactly what I want. > The problem is that it doesn't work most probably because the mp > cannot communicate with lp and lp stays ins "CARD_STATE_REBOOT" > > #Show module > S4: Invalid Module CARD_STATE_REBOOT 0 000c.dbe1.2f90 > --> no success > _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
