CER's don't have CAM profiles. From the information I can find, they
don't actually use TCAM anyway.
On 9/6/2017 3:32 PM, Derek wrote:
Did you check the CAM utilization? It's probably full, perhaps you
can partition it differently.
On Wed, Sep 6, 2017 at 2:30 PM, Brian Rak <[email protected]
<mailto:[email protected]>> wrote:
Has anyone else seem problems with the CER's being unable to add
routes before? We have multiple devices (all 2024C-4X) reporting
one or both of these messages:
IPv6 Route ADD: CAM entry creation FAILED
IPv4 Network Route ADD: CAM entry creation FAILED
They're learning a full v4+v6 table, but we are well below the
limits defined in `sh default values`. From past experience, a
reload seems to be the only thing that will actually correct this,
but that is a pretty annoying thing to have to do.
Any ideas for what may be causing this? We're on 5.6.0m right now.
_______________________________________________
foundry-nsp mailing list
[email protected] <mailto:[email protected]>
http://puck.nether.net/mailman/listinfo/foundry-nsp
<http://puck.nether.net/mailman/listinfo/foundry-nsp>
--
Be Well,
Derek Labian
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
