--- In [email protected], "Geert Vancompernolle" <[EMAIL PROTECTED]> wrote: > > Hi, > > When starting up the board, I get the following error message in > between all other messages shown when starting up the board: > > gpio init > GPIO port G: in_bits: 0x01FFFF3F out_bits: 0x3200003E val: F13F7FFF > GPIO port G: dir: 00000000 changeable: 01FFFF01 > ETRAX 100LX GPIO driver v2.5, (c) 2001, 2002, 2003, 2004 Axis > Communications AB > err: timer0 irq for gpio > err: PA irq for gpio > > Has anyone else seen something similar? I'm using Phrozen SDK, beta 1 > (as far as this could be interesting to know...). > > What's the cause of this problem? Can't remember if this is a new > error or if it has been there from the very beginning I started to use > Phrozen SDK. > > Best rgds, > > --Geert >
Hello Geert, I have it also. I detected it as I was integrating the RTC. I do'nt know if it was there before. Best regards, Thomas
