Hi, the FoxConsole is already inverting the pins so you need only to connect the Fox Console DB9 connector with a straight serial cable to your PC serial port. Set no hardware flow control and you need only to connect 2-2; 3-3; 5-5. You can also use a standard complete straight cable with 9 wires female-male to connect the FoxConsole to your serial PC port.
Also the default connection parameters for the ttyS0 debug/console serial port are: 115200, N, 8, 1. Best regards, Roberto Asquini hrmvb ha scritto: > > I just plugged it into the FoxServe board, connected a null modem > cable (see pin-out) between PC and Foxconsole, configured > Hyperterminal for 19200N81, no flow control, but I don't get anything > in Hyperterminal. > > null modem cable > pins pins > ----------- > 1,6 - 4 > 2 - 3 > 3 - 2 > 4 - 1,6 > 5 - 5 > 7 - 8 > 8 - 7 > > Does anybody know how to check which part has problems, cable or > Foxconsole? > > - Harm > > > > __________ Informazione NOD32 2187 (20070413) __________ > > Questo messaggio รจ stato controllato dal Sistema Antivirus NOD32 > http://www.nod32.it -- Roberto Asquini Acme Systems srl [EMAIL PROTECTED] http://www.acmesystems.it
