Hi Cchechio, using our Fox GM with the Fox Board, J6 and J7 headers are occupied with the GM board itself. You have possibility to use some I/O through the P1 connector on the GM (look at the photo, it is named as "Audio in,out and general I/O". See the schematic: http://www.acmesystems.it/articles/00003/FOXGM_schematic.pdf
On P1 there are the following GPIO lines of port G: IOG0 bidirectional IOG24 bidirectional IOG13 IOG14 IOG15 bidirectional but all three together with same direction IOG16 IOG17 IOG18 IOG19 bidirectional but all four together with same direction With these lines it is possible to interface several devices. Moreover there are two pushbuttons user defined connected respectively to Ig2 and Ig4 that can be used as input lines. Best regards, Roberto Asquini cchechio ha scritto: > > Is it true that If i use the modem of article > > http://www.acmesystems.it/?id=3 <http://www.acmesystems.it/?id=3> > > i occupy all input and output of fox. > > if no what are others in/out lines ? > > > > __________ Informazione NOD32 2187 (20070413) __________ > > Questo messaggio รจ stato controllato dal Sistema Antivirus NOD32 > http://www.nod32.it -- Roberto Asquini Acme Systems srl [EMAIL PROTECTED] http://www.acmesystems.it
