Hi, I am using the kernel 2.6.
http://www.acmesystems.it/articles/00033/zydas.pdf I want to use the zydas 1211 USB WLAN dongle and I did it in the way mentioned in the documentation. $ ifconfig [EMAIL PROTECTED] /etc/conf.d]104# [EMAIL PROTECTED] /etc/conf.d]104# ifconfig eth0 Link encap:Ethernet HWaddr 00:40:8C:01:15:58 inet addr:192.168.178.210 Bcast:192.168.178.255 Mask:255.255.25 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:577 errors:0 dropped:0 overruns:0 frame:0 TX packets:261 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:49283 (48.1 KiB) TX bytes:46654 (45.5 KiB) Interrupt:17 DMA chan:1 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) I expected a new interface device: eg. eth1 (for the zd1211) Jan 1 00:02:12 axis-00408c011558 kernel: |__ / _| _ \ / \ / ___| Jan 1 00:02:12 axis-00408c011558 kernel: / / | | | | | |/ _ \ \___ \ Jan 1 00:02:12 axis-00408c011558 kernel: / /| |_| | |_| / ___ \ ___) | Jan 1 00:02:12 axis-00408c011558 kernel: /____\__, |____/_/ \_\____/ Jan 1 00:02:12 axis-00408c011558 kernel: |___/ Jan 1 00:02:12 axis-00408c011558 kernel: ZD1211B - version 2.16.0.0 Jan 1 00:02:12 axis-00408c011558 kernel: vendor_id = 0ace Jan 1 00:02:12 axis-00408c011558 kernel: product_id = 1215 Jan 1 00:02:12 axis-00408c011558 kernel: USB 1.1 Host Jan 1 00:02:12 axis-00408c011558 kernel: Release Ver = 4810 Jan 1 00:02:12 axis-00408c011558 kernel: EEPORM Ver = 4810 The kernel module was already loaded, but I cannot configure the missing network device. Any ideas? best regards Michael
