Hi Thomas,
First, what is not working?
Do you want more light or nothing is working??
Do you receive any bug message?
You can check it:
1) Can you check at console port messages (J10) what is happing?? Normally this
port is using like a system message...
You can try to restore the factory settings:
2) Following the steps:
a) If you make errors during file manipulation of the FOX filesystem and get
stuck with the board not responding anymore or not booting at all you can
restore the original factory settings switching off the board and then
switching it on during pressing the SW1 switch for approximately ten seconds.
b) Switch then the Fox off again and then on without pressing the switch. You
will be reverted to the original condition of the read/write filesystem.
c) You will loose all your modifications done on the files in the read/write
directory /etc that will be reverted to the factory default. To revert deeper
modifications you will have to reflash the Fox board with the SDK environment.
d) If this procedure doesn't work if you got stuck during the flashing process
and damage the kernel read only partition flash contents. In this case you have
to use the LAN flashing procedure to recover the board: This article describes
how to reprogram the FLASH memory of the FOX board.
Please access the website: http://foxlx.acmesystems.it/?id=704
At this website you have some flash memories, choose one that best fit in your
board. And more below you have the article: How to reflash a FOX Board This is
will explain to you how to reflash the memory...
I hope that this information could help a little... Let me know...
Anyway, thanks for the opportunity to help you..,.
Kind Regards,
Marcelo
+55 31 91558911
____________________________________________________________________________________
Veja quais são os assuntos do momento no Yahoo! +Buscados
http://br.maisbuscados.yahoo.com
