Hello there,
I am using Ubuntu/Jaunty on my HP EliteBook 8530p with an Authentec
device (see below) and installed fprint (usual packages + libusb-1.0 +
corresponding /etc/pam.d/common-auth configuration).
Both, fprint_demo and pam_fprint_enroll are reporting "No devices
detected." when I want to enroll my fingerprint for later authentication
with pam.
Is it possible that my reader is not supported by fprint yet?
I don't know, why this reader has not a specific product id.
Many thanks for any help in advance,
Mario
PS: Device Info:
lsusb -s 4:2 -v
Bus 004 Device 002: ID 08ff:2810 AuthenTec, Inc.
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 255 Vendor Specific Class
bDeviceSubClass 255 Vendor Specific Subclass
bDeviceProtocol 255 Vendor Specific Protocol
bMaxPacketSize0 8
idVendor 0x08ff AuthenTec, Inc.
idProduct 0x2810
bcdDevice 17.03
iManufacturer 0
iProduct 1 Fingerprint Sensor
iSerial 0
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 32
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0xa0
(Bus Powered)
Remote Wakeup
MaxPower 100mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 2
bInterfaceClass 255 Vendor Specific Class
bInterfaceSubClass 255 Vendor Specific Subclass
bInterfaceProtocol 255 Vendor Specific Protocol
iInterface 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0040 1x 64 bytes
bInterval 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x02 EP 2 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0008 1x 8 bytes
bInterval 0
Device Status: 0x0000
(Bus Powered)
_______________________________________________
fprint mailing list
[email protected]
http://lists.reactivated.net/mailman/listinfo/fprint
