Unfortunately, no. FM's ruler only goes down to 1/8", 1/10", or 1/12".
From: "Mike Huffman" <[email protected]> To: <[email protected]> Date: 08/25/2011 09:17 AM Subject: Ruler Display Sent by: [email protected] Is there a way in FM 7.2 to change the ruler display to be 1/16 inches? Mike Huffman Technical Publications Astec Underground 9600 Corporate Park Drive Loudon, TN 37774 865.458.8471 [email protected] *********************************************************************** DISCLAIMER: This transmission from Astec Industries or one of its subsidiaries is confidential and solely for the use of the intended recipient. If you have received this email in error, please notify the sender and delete and destroy the original transmission and all copies. Our company accepts no liability for the contents of this email, or for the consequences of any actions taken on the basis of the information provided, unless that information is subsequently confirmed in writing. Please note that any personal views or opinions presented in this email are solely those of the author and do not necessarily represent those of the company. Finally, the recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email. _______________________________________________ You are currently subscribed to framers as [email protected]. Send list messages to [email protected]. To unsubscribe send a blank email to [email protected] or visit http://lists.frameusers.com/mailman/options/framers/lgold%40us.ibm.com Send administrative questions to [email protected]. Visit http://www.frameusers.com/ for more resources and info.
_______________________________________________ You are currently subscribed to framers as [email protected]. Send list messages to [email protected]. To unsubscribe send a blank email to [email protected] or visit http://lists.frameusers.com/mailman/options/framers/archive%40mail-archive.com Send administrative questions to [email protected]. Visit http://www.frameusers.com/ for more resources and info.
