Dear framers
Using the PDFX3 joboptions on an FM document is not possible using the Save as
PDF route.
For this format I need to print to PS and then distill. And it turns out that I
must not check Create
Acrobat Data in the print dialogue (which is not available in the Save As PDF
route).
Otherwise I get lots of violations (see log below).
Why is this? I'm not familiar with the requiremens of the X-process (use it on
demand of print-shop).
Thank You for inspiration!
Acrobat 9.5.2, FrameMaker 10.0.3.419
--------------------------------------------------------------------
PDF/X Compliance Report
1. Content
[Violation] Annotations were found inside the BleedBox, TrimBox, or ArtBox
on the following pages:
Page 1, Occurrences: 51
Page 15, Occurrences: 1
Page 18, Occurrences: 1
Page 27, Occurrences: 1
Page 28, Occurrences: 1
Page 30, Occurrences: 1
Page 31, Occurrences: 4
Page 32, Occurrences: 1
Page 33, Occurrences: 1
Page 50, Occurrences: 1
Page 51, Occurrences: 2
Page 56, Occurrences: 1
Page 58, Occurrences: 1
Violations: The total found in this section was 67.
2. Summary
Warnings: The total found in this document was 0.
Violations: The total found in this document was 67.
This document does not pass PDF/X-3:2002 compliance checks.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Docu + Design Daube; Sch?racher 11; CH-8053 Z?rich
Technical documentation & consultancy; On-line and paper
F: +41-44-422 86 25 E: ddd at daube.ch W: www.daube.ch
