Just checked Chambless-- yes, the ESC has been 'delisted.' Apparently too some of the ESC's over the years have been ELJs re-branded, so it's an acceptable substitute. Yeah, that guy has them for like $14, but they might be ELJs according to some people.
The 8mm Forum boys may have a good solution for this. [email protected] -----Original Message----- From: Adam Hyman <[email protected]> To: Experimental Film Discussion List <[email protected]> Sent: Thu, May 9, 2013 4:51 pm Subject: Re: [Frameworks] ESC bulbs Hi, Yes, the ESC is the preferred bulb, (thus, the subject line of my email) and it appears the ELJ is an acceptable substitute. I haven’t tried either of those. I did buy 4 ESC bulbs from replacementlightbulbs.com in North Carolina, and we shall see if that comes through. Best, Adam On 5/9/13 4:43 PM, "[email protected]" <[email protected]> wrote: Did you try Spectra in North Hollywood? Is Chambless still around, in Georgia? Does the GS-1200 take ESC? -----Original Message----- From: Adam Hyman <[email protected]> To: Experimental Film Discussion List <[email protected]> Sent: Thu, May 9, 2013 2:38 pm Subject: Re: [Frameworks] ESC bulbs Thanks! On 5/9/13 11:51 AM, "Madison Brookshire" <[email protected]> wrote: JD Audio Visual in Pasadena is looking into whether they can order ESC right now, but from the sound of Buck's reply, they might not have any luck. You can also try General Camera: http://www.generalcamera.net/ GENERAL CAMERA REPAIR 2218 E. Colorado Blvd Pasadena, Ca 91107 2 Blocks West of Sierra Madre Blvd We are on the South side of Colorado Cross Street is Grand Oaks TEL: 626-449-4533 FAX: 626-449-7472 On Thu, May 9, 2013 at 11:25 AM, 40 Frames <[email protected]> wrote: Adam, Have you tried any of the ones listed here... http://www.16mmdirectory.org/projectors/lamps Alain On Thu, May 9, 2013 at 10:28 AM, Adam Hyman <[email protected]> wrote: And I just found out that Bulbtronics in Burbank no longer has them, and says they can no longer get them. Best, Adam On 5/9/13 10:02 AM, "Adam Hyman" <[email protected]> wrote: Sorry, I meant GS-1200. On 5/9/13 9:57 AM, "Adam Hyman" <[email protected]> wrote: Hi, Anyone have recommended sources for ESC bulbs for an Elmo GL-1200 super8mm projector, ideally in Los Angeles, but I’ll go for the USA if possible? Best, Adam _______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks _______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks _______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks _______________________________________________FrameWorks mailing [email protected]https://mailman-mail5.webfaction.com/listinfo/frameworks _______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks
_______________________________________________ FrameWorks mailing list [email protected] https://mailman-mail5.webfaction.com/listinfo/frameworks
