On Thursday, September 18, 2014 05:30:17 PM Sevan / Venture37 wrote: > Hi, > Following the thread on getting resume working on the T61[1], I > factory reset my BIOS once more but this time confirmed the modem was > enabled. Resuming then worked fine on 11-CURRENT r270990 AMD64. > hw.acpi.reset_video=1 needs to be set otherwise system resumes without > switching the system back on.
You only need reset_video with syscons, correct? > With vt & i915kms, when the system goes to sleep, it reports (trimmed): > pci5: failed to set ACPI power state D2 on \134_SB_.PCI0.PCI1.CDBS: > AE_BAD_PARAMETER > pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.EXP0: > AE_BAD_PARAMETER pci0: failed to set ACPI power state D2 on > \134_SB_.PCI0.EXP1: AE_BAD_PARAMETER acpi0: cleared fixed power button > status > > and when it wakes, it reports > uhci_interrupt: resume detect > error: [drm:pid786:intel_lvds_enable] *ERROR* timed out waiting for > panel to power off I get the panel error on resume everytime on my x220, but it still works fine. > With sys cons, , when the system goes to sleep, it reports: > pci5: failed to set ACPI power state D2 on \_SB_.PCI0.PCI1.CDBS: > AE_BAD_PARAMETER > pci0: failed to set ACPI power state D2 on \_SB_.PCI0.EXP0: AE_BAD_PARAMETER > pci0: failed to set ACPI power state D2 on \_SB_.PCI0.EXP1: > AE_BAD_PARAMETER acpi0: cleared fixed power button status > > I've not had a chance to test X or the USB ports. To be clear, is it resuming ok in all of your tests, just logging these messages? I think you can ignore the mesages about power states and the panel power off error. -- John Baldwin _______________________________________________ freebsd-acpi@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-acpi To unsubscribe, send any mail to "freebsd-acpi-unsubscr...@freebsd.org"