On 11/30/11 3:42 PM, Thomas D. Dean wrote:
On Wed, 2011-11-30 at 20:18 +0100, Tomasz Kowalczyk wrote:
Hello
I think you don't even need to go 'back' to boot frequency. I suggest using
powerd(8) to save some power and lower the temperature.
Put it in /etc/rc.conf :
powerd_enable="YES"
powerd_flags="-a adp -m 800"
Making this change and starting powerd put me back to the state where
dev.cpu.0.temperature: 83.0C # changing 82..85
dev.cpu.0.freq: 2301
I am confused about what side effect modified behavior when I changed
dev.cpu.0.freq initially. Somehow, this change got the system away from
the boot state.
Since then, I have not seen the state where dev.cpu.0.temperature was in
the low to mid 70's.
When I have dev.cpu.0.freq: 2012, dev.cpu.0.temperature is below 60C.
When I have dev.cpu.0.freq: 2301, dev.cpu.0.temperature is above 80C.
So, the load on the CPU is not the same as when in the boot state.
I don't understand this.
Did you try setting the frequency to 800 and seeing what the temperature
was? Also, are the 2301 vs 2310 mismatches typos or did it actually set
the speed to 2310 when you asked for 2301?
--
John Baldwin
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-amd64
To unsubscribe, send any mail to "[email protected]"
