asus p2b-ds, dual P2/350s, 128mb
current as of 99.08.13 evening

dmesg has a few things which worry me.  but the hauppauge/brootree works
fine with mbone tools and fxtv.


Copyright (c) 1992-1999 The FreeBSD Project.
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California. All rights reserved.
FreeBSD 4.0-CURRENT #0: Sat Aug 14 09:01:38 PDT 1999
    [EMAIL PROTECTED]:/usr/src/sys/compile/RIP
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium II/Xeon/Celeron (686-class CPU)
  Origin = "GenuineIntel"  Id = 0x651  Stepping = 1
real memory  = 134205440 (131060K bytes)
config> pnp 1 0 enable os port0 0x220 port1 0x330 port2 0x388 irq0 5 drq0 1 drq1 5
config> pnp 1 1 enable os port0 0x200
config> pnp 1 2 enable os port0 0x620 port1 0xa20 port2 0xe20
config> quit
avail memory = 126959616 (123984K bytes)
Programming 24 pins in IOAPIC #0
FreeBSD/SMP: Multiprocessor motherboard
 cpu0 (BSP): apic id:  1, version: 0x00040011, at 0xfee00000
 cpu1 (AP):  apic id:  0, version: 0x00040011, at 0xfee00000
 io0 (APIC): apic id:  2, version: 0x00170011, at 0xfec00000
Preloaded elf kernel "kernel" at 0xc02f5000.
Preloaded userconfig_script "/kernel.config" at 0xc02f509c.
Pentium Pro MTRR support enabled
ccd0-5: Concatenated disk drivers
Probing for PnP devices:
CSN 1 Vendor ID: CTL00c3 [0xc3008c0e] Serial 0x1fd0a682 Comp ID: PNPb02f [0x2fb0d041]
pcm1 (SB16pnp <SB16 PnP> sn 0x1fd0a682) at 0x220-0x22f irq 5 drq 1 flags 0x15 on isa
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
WARNING: "bktr" is usurping "bktr"'s cdevsw[]        <<<***********************
pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
vga-pci0: <Matrox model 051f graphics accelerator> irq 16 at device 0.0 on pci1
isab0: <Intel 82371AB PCI to ISA bridge> at device 4.0 on pci0
chip1: <Intel PIIX4 IDE controller> at device 4.1 on pci0
chip2: <UHCI USB controller> irq 19 at device 4.2 on pci0
intpm0: <Intel 82371AB Power management controller> at device 4.3 on pci0
intpm0: I/O mapped e800
intpm0: intr IRQ 9 enabled revision 0
smbus0: <System Management Bus> on intsmb0
smb0: <SMBus general purpose I/O> on smbus0
intpm0: PM I/O mapped e400 
ahc0: <Adaptec aic7890/91 Ultra2 SCSI adapter> irq 19 at device 6.0 on pci0
ahc0: aic7890/91 Wide Channel A, SCSI Id=7, 16/255 SCBs
fxp0: <Intel EtherExpress Pro 10/100B Ethernet> irq 19 at device 9.0 on pci0
fxp0: Ethernet address 00:a0:c9:df:c8:4e
bktr0: <BrookTree 878> irq 18 at device 10.0 on pci0
iicbb0: <I2C generic bit-banging driver> on bti2c0
iicbus0: <Philips I2C bus> on iicbb0 master-only
iicsmb0: <I2C to SMB bridge> on iicbus0
smbus1: <System Management Bus> on iicsmb0
smb1: <SMBus general purpose I/O> on smbus1
WARNING: "iic" is usurping "iic"'s cdevsw[]          <<<***********************
iic0: <I2C general purpose I/O> on iicbus0
smbus2: <System Management Bus> on bti2c0
smb2: <SMBus general purpose I/O> on smbus2
Hauppauge Model 61111 A M 
Hauppauge WinCast/TV, Philips NTSC tuner, msp3400c stereo.
Detected a MSP3430G-A1
pci0: unknown card DD^0878 (vendor=0x109e, dev=0x0878) at 10.1 irq 18
isa0: <ISA bus> on motherboard
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <keyboard controller (i8042)> at port 0x60-0x6f on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3b0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <4 virtual consoles, flags=0x200>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
wl0 at port 0x300-0x30f irq 7 on isa0
wl0: address 08:00:6a:2b:dd:a7, NWID 0xaaaa
APIC_IO: Testing 8254 interrupt delivery
APIC_IO: routing 8254 via pin 2
wl0 XXX: driver didn't set ifq_maxlen
Waiting 15 seconds for SCSI devices to settle
SMP: AP CPU #1 Launched!
sa0 at ahc0 bus 0 target 6 lun 0
sa0: <DEC DLT2000 8B37> Removable Sequential Access SCSI-2 device 
sa0: 5.000MB/s transfers (5.000MHz, offset 15)
changing root device to da0s1a
da0 at ahc0 bus 0 target 0 lun 0
da0: <SEAGATE ST34573LW 5702> Fixed Direct Access SCSI-2 device 
da0: 80.000MB/s transfers (40.000MHz, offset 15, 16bit), Tagged Queueing Enabled
da0: 4340MB (8888924 512 byte sectors: 255H 63S/T 553C)
da1 at ahc0 bus 0 target 1 lun 0
da1: <SEAGATE ST34573LW 5702> Fixed Direct Access SCSI-2 device 
da1: 80.000MB/s transfers (40.000MHz, offset 15, 16bit), Tagged Queueing Enabled
da1: 4340MB (8888924 512 byte sectors: 255H 63S/T 553C)
cd0 at ahc0 bus 0 target 4 lun 0
cd0: <TEAC CD-ROM CD-532S 1.0A> Removable CD-ROM SCSI-2 device 
cd0: 20.000MB/s transfers (20.000MHz, offset 16)
cd0: Attempt to query device size failed: NOT READY, Medium not present
cd1 at ahc0 bus 0 target 5 lun 0
cd1: <YAMAHA CRW4416S 1.0f> Removable CD-ROM SCSI-2 device 
cd1: 8.333MB/s transfers (8.333MHz, offset 31)
cd1: cd present [140956 x 2048 byte records]

To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message

Reply via email to