I've had an ATAPI CDROM as master and an HP Colorado tape as slave set up on my system for quite some time now. I recently migrated to 4.0 and I'm using the new ATA drivers. Below is a snip from my kernel config: controller ata0 device atadisk0 device atapicd0 device atapist0 At boot time, the messages show that there are two devices on the channel, but only the CDROM is configured. Any ideas? ata0: Aladdin: two atapi devices on this channel, DMA disabled atapi: MODE_SENSE_BIG - UNIT ATTENTION skey=6 asc=29 ascq=00 error=00 acd0: <DELTA OPC-K101/ST1 F/W by OIPD/VER-3.40> CDROM drive at ata0 as master acd0: read 687KB/s (6875KB/s), 128KB buffer, PIO acd0: supported read types: CD-R, CD-RW, CD-DA, packet acd0: Audio: play, 255 volume levels acd0: Mechanism: ejectable tray acd0: Medium: no/blank disc inside, unlocked ========================================================== = Bryan D. Liesner LeezSoft Communications, Inc. = = A subsidiary of LeezSoft Inc. = = [EMAIL PROTECTED] Home of the Gipper = ========================================================== To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-current" in the body of the message
