On 01/06/14 11:15, Huang Wen Hui wrote:
2014/1/6 Hans Petter Selasky <h...@bitfrost.no>

On 01/06/14 10:41, Huang Wen Hui wrote:

% grep xhci dmesg-xhci-debug.txt | more
xhci0: <Intel Lynx Point USB 3.0 controller> mem 0xc1e00000-0xc1e0ffff at
device 20.0 on pci0
xhci0: attempting to allocate 1 MSI vectors (8 supported)
xhci0: using IRQ 266 for MSI
xhci0: MSI enabled

Those USB timeouts are most likely due to port routing not working
properly. It is because intel did something special to their lynx point

Try to set :

hw.usb.xhci.xhci_port_route = "-1"

in /boot/loader.conf

Try this before,  hw.usb.xhci.xhci_port_route = "-1" make almost of all usb
devices not found.

external mouse seems to no power at all.

# usbconfig list
ugen0.1: <XHCI root HUB 0x8086> at usbus0, cfg=0 md=HOST spd=SUPER
(5.0Gbps) pwr=SAVE (0mA)
ugen0.2: <product 0x8406 vendor 0x05ac> at usbus0, cfg=255 md=HOST
spd=SUPER (5.0Gbps) pwr=ON (100mA)


If you check using pciconf -lv, is there a USB controller which has no driver attached? Typically there should be an EHCI/OHCI/UHCI companion controller. When the port route is set to -1 these devices should attach to the companion controller instead.


freebsd-current@freebsd.org mailing list
To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"

Reply via email to