On 3/1/16, Carsten Kunze <carsten.ku...@arcor.de> wrote:
> Conrad Meyer <c...@freebsd.org> wrote:
>> " iwn0: <Intel Centrino Advanced 6235> mem 0xf7b00000-0xf7b01fff
>> irq 18 at device 0.0 on pci3" is fine; "module iwn already present!"
>> is fine.
>> What makes you say it isn't recognized or doesn't work?
> ifconfig iwn0 .... says "interface iwn0 does not exist". Also starting
> wpa_supplicant doesn't work (I use a wpa setup that did work on my previous
> laptop on FreeBSD 10).
The wireless subsystem changed a lot since 10-STABLE, and there are no
more iwn interfaces shown via ifconfig.
You could query them as Adrian mentioned.
If you successfully upgraded your base system _too_ and not just the
kernel, then you should put a similar lines into rc.conf:
ifconfig_wlan0="WPA DHCP country HU -wme -powersave"
And you should put the relevant firmware module's loading request into
/boot/loader.conf, this was mentioned in one mail before.
> At install time I only "configured" ethernet, iwn0 I skipped since I
> intented to configure that later. But that may not be relevant.
> email@example.com mailing list
> To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"
firstname.lastname@example.org mailing list
To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"