On 15 Jun, Michael Class wrote:

> after the recent linker_set-changes on my system the ps2-mouse

I thought the recent change to config was the problem (forgetting the
hints also disables the mouse).

> is not working any more. It seems that a second (virtual ;-)
> keyboard is detected (atkbd1) and that this messes up things.

world/kernel from June 14, ~2pm CET.

Same here:
Copyright (c) 1992-2001 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #14: Thu Jun 14 19:54:51 CEST 2001
    [EMAIL PROTECTED]:/big/usr/src/sys/compile/WORK
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium II/Pentium II Xeon/Celeron (400.94-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x665  Stepping = 5
real memory  = 268423168 (262132K bytes)
avail memory = 256872448 (250852K bytes)
Preloaded elf kernel "kernel" at 0xc0435000.
Preloaded elf module "cd9660.ko" at 0xc043509c.
Preloaded elf module "linux.ko" at 0xc043513c.
Preloaded elf module "snd_pcm.ko" at 0xc04351dc.
Preloaded elf module "snd_sbc.ko" at 0xc043527c.
Preloaded elf module "snd_sb16.ko" at 0xc043531c.
Preloaded elf module "usb.ko" at 0xc04353bc.
Preloaded elf module "agp.ko" at 0xc0435458.
Preloaded elf module "accf_data.ko" at 0xc04354f4.
Preloaded elf module "accf_http.ko" at 0xc0435598.
Preloaded elf module "atspeaker.ko" at 0xc043563c.
Preloaded elf module "joy.ko" at 0xc04356e0.
Pentium Pro MTRR support enabled
VESA: v3.0, 16384k memory, flags:0x1, mode table:0xc0339617 (1000117)
VESA: 3dfx Interactive, Inc.
Using $PIR table, 7 entries at 0xc00f0d10
apm0: <APM BIOS> on motherboard
apm0: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443LX (440 LX) host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
agp0: <Intel 82443LX (440 LX) host to PCI bridge> mem 0xe0000000-0xe7ffffff at device 
0.0 on pci0
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <display, VGA> at 0.0 (no driver attached)
isab0: <PCI-ISA bridge> at device 4.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xb800-0xb80f at device 4.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xb400-0xb41f irq 9 at device 
4.2 on pci0
usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
intpm0: <Intel 82371AB Power management controller> port 0xe800-0xe80f irq 9 at device 
4.3 on pci0
intpm0: I/O mapped e800
intpm0: intr IRQ 9 enabled revision 0
smbus0: <System Management Bus> on intsmb0
smb0: <SMBus general purpose I/O> on smbus0
intpm0: PM I/O mapped e400 
ahc0: <Adaptec aic7880 Ultra SCSI adapter> port 0xb000-0xb0ff mem 
0xd9800000-0xd9800fff irq 9 at device 6.0 on pci0
aic7880: Ultra Wide Channel A, SCSI Id=7, 16/255 SCBs
ed0: <NE2000 PCI Ethernet (RealTek 8029)> port 0xa800-0xa81f irq 9 at device 10.0 on 
ed0: address 00:80:ad:40:bd:e7, type NE2000 (16 bit) 
orm0: <Option ROMs> at iomem 0xc0000-0xc7fff,0xc8000-0xc87ff on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
atkbd1: <AT Keyboard> irq 1 on atkbdc0
kbd1 at atkbd1
psm1: unable to allocate the IRQ resource (12).
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
isic0 at port 
 irq 3 flags 0x4 on isa0
isic0: passive stack unit 0
isic0: AVM A1 or Fritz!Card Classic
pca0 at port 0x40 on isa0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/9 bytes threshold
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
pcfclock0: <PCF-1.0> on ppbus0
ppi0: <Parallel I/O> on ppbus0
pps0: <Pulse per second Timing Interface> on ppbus0
sc0: <System console> at flags 0x6 on isa0
sc0: VGA <16 virtual consoles, flags=0x206>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x20010 on isa0
sio0: type ST16650A
sio1 at port 0x2e8-0x2ef irq 10 flags 0x20000 on isa0
sio1: type ST16650A
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
vga1: <Generic ISA VGA> at port 0x3b0-0x3bb iomem 0xb0000-0xb7fff on isa0
sc1: <System console> at flags 0x6 on isa0
sc1: MDA <16 virtual consoles, flags=0x6>
WARNING: Driver mistake: repeat make_dev("consolectl")
fdc1: cannot reserve I/O port range
pca1 at port 0x40 on isa0
WARNING: Driver mistake: repeat make_dev("pcaudio")
WARNING: Driver mistake: repeat make_dev("pcaudioctl")
isic1: Could not get iobase for AVM A1/Fritz!
ppc1: parallel port not found.
sbc0: <Creative ViBRA16C> at port 0x220-0x22f,0x330-0x331,0x388-0x38b irq 5 drq 1,5 on 
pcm0: <SB16 DSP 4.13> on sbc0
joy0: <Generic PnP Joystick> at port 0x200-0x207 on isa0
unknown: <PNP0401> can't assign resources
unknown: <PNP0501> can't assign resources
unknown: <PNP0501> can't assign resources
unknown: <PNP0700> can't assign resources
unknown: <PNP0f13> can't assign resources
unknown: <PNP0303> can't assign resources
pca2: <AT-style speaker sound> at port 0x61 on isa0
WARNING: Driver mistake: repeat make_dev("pcaudio")
WARNING: Driver mistake: repeat make_dev("pcaudioctl")
i4bctl: ISDN system control port attached
i4brbch: 2 raw B channel access device(s) attached
i4bisppp: 2 ISDN SyncPPP device(s) attached (VJ header compression)
IP packet filtering initialized, divert disabled, rule-based forwarding disabled, 
default to deny, logging limited to 100 packets/entry by default
i4b: ISDN call control device attached
i4btrc: 2 ISDN trace device(s) attached
ad0: 19547MB <FUJITSU MPE3204AT> [39714/16/63] at ata0-master UDMA33
afd0: 96MB <IOMEGA ZIP 100 ATAPI> [32/64/96] at ata1-master PIO0
Waiting 5 seconds for SCSI devices to settle
Mounting root from ufs:/dev/ad0s2a
cd0 at ahc0 bus 0 target 1 lun 0
cd0: <TEAC CD-R55S 1.0Q> Removable CD-ROM SCSI-2 device 
cd0: 10.000MB/s transfers (10.000MHz, offset 15)
cd0: Attempt to query device size failed: NOT READY, Medium not present
cd1 at ahc0 bus 0 target 2 lun 0
cd1: <PIONEER CD-ROM DR-U16S 1.01> Removable CD-ROM SCSI-2 device 
cd1: 20.000MB/s transfers (20.000MHz, offset 15)
cd1: Attempt to query device size failed: NOT READY, Medium not present
afd0: reading primary partition table: error reading fsbn 0
i4b-L2 i4b_T202_timeout: unit 0, N202 = 3
i4b: unit 0, assigned TEI = 125 = 0x7d
pid 1013 (k3d), uid 1000: exited on signal 11 (core dumped)
pid 997 (k3d), uid 1000: exited on signal 11 (core dumped)
sio0: 85 more interrupt-level buffer overflows (total 85)
sio0: 64 more interrupt-level buffer overflows (total 149)
sio0: 40 more interrupt-level buffer overflows (total 189)


                   It's not a bug, it's tradition!

http://www.Leidinger.net                       Alexander @ Leidinger.net
  GPG fingerprint = C518 BC70 E67F 143F BE91  3365 79E2 9C60 B006 3FE7

To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message

Reply via email to