hi, there!

On Tue, Feb 05, 2002 at 08:14:22PM +0100, Thomas Quinot wrote:

> > Is there a place where I can find this updated patch which will work for 
> > me in the current -current?  Thanks.
> I put up updated patches at
>   http://www.cuivre.fr.eu.org/~thomas/atapicam/
> For -CURRENT, you should be using the latest one (of today)
> which fixes a silly line inversion.
> I'd be very interested in success/failuire reports on this patch,
> especially with ATAPI tape or floppy drives.

I successfully recorded data cd using cdrecord on NEC NR-7700A IDE CD-RW.
dmesg follows

Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 4.5-STABLE #0: Thu Feb  7 04:49:06 NS 2002
    [EMAIL PROTECTED]:/usr/obj/usr/fbsd/RELENG_4/src/sys/husky
Timecounter "i8254"  frequency 1193182 Hz
CPU: AMD-K7(tm) Processor (503.53-MHz 686-class CPU)
  Origin = "AuthenticAMD"  Id = 0x612  Stepping = 2
  AMD Features=0xc0400000<AMIE,DSP,3DNow!>
real memory  = 268369920 (262080K bytes)
config> enable apm0
config> quit
avail memory = 256040960 (250040K bytes)
Preloaded elf kernel "kernel" at 0xc04af000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc04af09c.
Preloaded elf module "if_ppp.ko" at 0xc04af0ec.
Pentium Pro MTRR support enabled
md0: Malloc disk
Using $PIR table, 7 entries at 0xc00f82b0
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <AMD-751 host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <AMD-751 PCI-PCI (1x/2x AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <NVidia Riva Ultra Vanta TNT2 graphics accelerator> at 5.0 irq 11
isab0: <VIA 82C686 PCI-ISA bridge> at device 4.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <VIA 82C686 ATA66 controller> port 0xffa0-0xffaf at device 4.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <VIA 83C572 USB controller> port 0xcc00-0xcc1f irq 12 at device 4.2 on pci0
usb0: <VIA 83C572 USB controller> on uhci0
usb0: USB revision 1.0
uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1: <VIA 83C572 USB controller> port 0xd000-0xd01f irq 12 at device 4.3 on pci0
usb1: <VIA 83C572 USB controller> on uhci1
usb1: USB revision 1.0
uhub1: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
chip1: <VIA 82C686 ACPI interface> at device 4.4 on pci0
pci0: <unknown card> (vendor=0x1274, dev=0x1371) at 13.0 irq 11
ed0: <NE2000 PCI Ethernet (RealTek 8029)> port 0xc400-0xc41f irq 5 at device 14.0 on 
ed0: address 00:00:01:00:fb:08, type NE2000 (16 bit) 
sym0: <810a> port 0xd800-0xd8ff mem 0xefffff00-0xefffffff irq 10 at device 15.0 on pci0
sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
orm0: <Option ROMs> at iomem 0xc0000-0xcffff,0xd0000-0xd3fff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
IP packet filtering initialized, divert enabled, rule-based forwarding disabled, 
default to deny, logging disabled
ad0: 9671MB <IBM-DTTA-351010> [19650/16/63] at ata0-master UDMA33
acd0: CD-RW <_NEC NR-7700A> at ata1-master using PIO4
(noperiph:atapi1:0:-1:-1): Registered SIM for ata1
Waiting 15 seconds for SCSI devices to settle
atapicam1m: read data overrun 96/95
Mounting root from ufs:/dev/ad0s2a
cd1 at atapi1 bus 0 target 0 lun 0
cd1: <_NEC NR-7700A 1.01> Removable CD-ROM SCSI-0 device 
cd1: 3.300MB/s transfers
cd1: cd present [347816 x 2048 byte records]
cd0 at sym0 bus 0 target 6 lun 0
cd0: <SONY CD-R   CDU948S 1.0e> Removable CD-ROM SCSI-2 device 
cd0: 10.000MB/s transfers (10.000MHz, offset 8)
cd0: cd present [327225 x 2048 byte records]
pcm0: <AudioPCI ES1373-8> port 0xc800-0xc83f irq 11 at device 13.0 on pci0


To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message

Reply via email to