With 4.5-release out the door, I thought I'd start trying to use
5.0-current on my "main freebsd machine" instead of 4.x-stable.  I
figure at some point we (as developers) have got to try to migrate
to that release as much as possible.

I had been doing some stuff with 5.0-current at home.  That seemed
a bit slow, but I didn't think too much of it as the home machine is
a single-CPU Duron-based machine (600 Mhz). while the machine at work
is a dual-CPU Pentium-3 machine (650 MHz).  The office machine also
has more RAM, so obviously the home machine would be slower.

But switching to current on the office machine is also considerably
slower.  I wasn't expecting "faster", but I'm wondering if other
people are also seeing it as much slower, or if I've just got some
other odd problem hitting me.

One simple test I tried was that I have a copy of the freebsd cvs
repository in /usr/cvs/free, on it's own partition.  Each system
has it's own /usr/src, of course.  I cvsup'ed /usr/cvs/free, and
then did a
      time cvs status >/dev/null
in each /usr/src, on each system.  (that command is just for this
timing test, I usually do more useful commands at that point!).

         On current      On stable
         ----------     ----------
real    7m 43.392s     4m 53.100s    in /usr/src for current
user    0m 11.692s     0m  4.203s
sys     3m  4.601s     0m  2.248s

real    6m 40.322s     2m 39.361s    in /usr/src for stable
user    0m 10.531s     0m  6.653s
sys     4m 28.863s     0m  9.480s

I realize this example isn't terribly detailed, but it seems to
match what I "feel" when doing any major work on current.  I'm
used to a 'make -j5 buildworld' taking between 42 and 45 minutes
for stable on my office machine, but the few times I've rebuilt
-current, it's taking more like three and a half hours.  That is
quite a hit.

This current system was initially installed in late-december, doing
a full system-install (booting off a CD, newfs'ing the partitions,
etc).  So, it should have picked up all the recent filesystem
improvements (dirprefs, etc) when laying out the files, and even if
that wasn't true this test is done using the exact same directories
as source & destination for the stable vs current tests.

Could it be due to the DDB, INVARIANTS & WITNESS options in the
kernel?  If it is that's fine with me, I'm just wondering where
that magnitude of a slowdown would be coming from.

Anything else I should check?  I realize there's about a million
differences between the two branches, and there might also be
something about my machine's setup which is a major culprit here.
I'm just looking for a basic idea of what other people have been
seeing for performance when they run current.

Garance Alistair Drosehn            =   [EMAIL PROTECTED]
Senior Systems Programmer           or  [EMAIL PROTECTED]
Rensselaer Polytechnic Institute    or  [EMAIL PROTECTED]

To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message

To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message

Reply via email to