On Fri, Sep 06, 2002 at 06:16:17PM +0200, Bernd Walter wrote:
> On Fri, Sep 06, 2002 at 06:09:59PM +0200, Bernd Walter wrote:
> > On Sat, Sep 07, 2002 at 12:05:54AM +0900, Shunsuke Akiyama wrote:
> > > Hi,
> > >
> > > At Thu, 5 Sep 2002 16:17:42 +0200,
> > > Bernd Walter wrote:
> > >
> > > > I've build a device which is based on the FT8U232AM chip.
> > > > Probing works like a charm:
> > > > cicely13# usbdevs -v | grep FTDI
> > > > port 3 addr 5: full speed, power 90 mA, config 1, USB <-> Serial(0x6001),
>FTDI(0x0403), rev 2.00
> > > > And I get a new node in /dev:
> > > > cicely13# ls -l /dev/ucom0
> > > > crw-rw---- 1 uucp dialer 138, 128 Sep 4 16:43 /dev/ucom0
> > > > But I get an error when writing:
> > > > cicely13# echo test > /dev/ucom0
> > > > /dev/ucom0: Device not configured.
> > > > cicely13# uname -a
> > > > FreeBSD cicely13.cicely.de 5.0-CURRENT FreeBSD 5.0-CURRENT #3: Wed Sep 4
>15:54:17 CEST 2002
> > >
> > > I've got a similar problem report with uvscom. And I also have this
> > > problem, too.
> > Good to hear that others have this problem too.
> > I wasn't shure if it's my fault buildung the device or the driver.
> > > Please try to attached patch.
> > > It's works fine for me.
> > Are you shure?
> > The patch just changes the name of the drivers.
> > Not surprisingly it did not solve my problem.
> Amazing - it works now if the device is plugged in at booting.
Mmm - it only works on the first open.
Sounds like there is much to do to get it working :(
B.Walter BWCT http://www.bwct.de
[EMAIL PROTECTED] [EMAIL PROTECTED]
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message