Dear sirs,
I located a hauppauge card that had a conexant 878a chipset on it. This is an
video capture card which should supposedly work under the brooktree driver. The
reason I say this is that I found a success story of somone using the pinnacle branded
card of the same chipset under freebsd 4-x. The following modules are loaded:
2 2 0xc086a000 36d4 iicbus.ko
3 2 0xc086e000 41d4 iicbb.ko
4 3 0xc0873000 3720 smbus.ko
5 1 0xc0877000 3080 smb.ko
6 1 0xc087b000 43b4 viapm.ko
7 2 0xc0880000 1f3c bktr_mem.ko
15 1 0xc44c5000 e000 bktr.ko
The relevant lines in dmesg on the other hand states that the driver isn't
appropriate...
viapropm0: SMBus I/O base at 0x6000
viapropm0: <VIA VT82C686A Power Management Unit> port 0x6000-0x600f at device 7.
4 on pci0
viapropm0: SMBus revision code 0x0
smbus0: <System Management Bus> on viapropm0
smb0: <SMBus generic I/O> on smbus0
pci0: <multimedia, video> at device 9.0 (no driver attached)
pci0: <multimedia> at device 9.1 (no driver attached)
And of course, the /dev/bktr* devices weren't created, but I've done
everything that I think I was suppose to do in the man page, I've emailed [EMAIL
PROTECTED] asking about the driver, is there anything I'm seemingly missing ? At any
rate, thank you for your time and attention, I don't know where else to look...
Bertrand
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
