On 4/14/05, Neo-Vortex <[EMAIL PROTECTED]> wrote: > > On Wed, 2005-04-13 at 16:38, M. Parsons wrote: > > > I was under the impression (but would need to check to make sure) that > > all incoming packets are diverted to ng_pppoe when it is hooked into the > > Ethernet interface. > > > > This would explain your problems. > > > > Can you try this without the interface being used for PPPOE? > > I have a single interface for PPPoE using netgraph and it connects to the > modem, and other computers fine > > > > For the record, http://www.broadbandreports.com/faq/9693 is the page > > > on how you access the line stats, and the MAC part is required for my > > > modem. > > The only reason i could think of as to why it is required, is if its ip > address isn't 10.0.0.1 as you think it is and for some strange reason it > accepts ip packets as its own if the ethernet header points to its MAC > address... try setting it to DHCP and see if you get an ip... else look up > the manufacturer for the default ip and try a factory reset >
I think things are going overboard here, Im just going to give up. I have tried it with pppoe being down, still couldnt connect to the modem. I was told on another msg board that if I did: ifconfig ed0 10.0.0.2 netmask 255.255.255.0 route add -host 10.0.0.1 -interface ed0 arp -s 10.0.0.1 00:0b:23:2a:b0:c4 would be the equivalent of the 3 linux commands, but alas, those 3 dont work either. Again, thanks to all that have tried, again, its just line stats, so I can live without them. Mark _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hackers To unsubscribe, send any mail to "[EMAIL PROTECTED]"
