yes, pciconfig -lv says "Texas Instruments (TI)"... but not more, not any
details of the chip, only that it is of class "networking".... at least for
the DWL-G520+, because for the TrendNet it says nothing...
this is weird, as for another PCI 100Mbps Ethernet Card the same slot and
others are working perfect, and when I insert these cards it seems they are
not properly detected...
anyway, I tried the ACX100 driver on my FreeBSD 5.2.1, installed from the
ports, but same 0% succes :(
and I did everything correctly, my if_acx module loads properly at boot.
if anyone has any other ideas... is anyone using one of these cards
actually?
on http://wlan.kewl.org darren, the developer of the acx100 driver�, said
smtg about using the NDIS wrapper for this card, as it works for him... but
I have no idea what this could mean... anyone who is doing this maybe?
tks again!
ANdrei
---
The question of whether computers can think is like the question of
whether submarines can swim. Edsgar W. Dijkstra (1930-2002)
----- Original Message -----
From: "Andrey Smagin" <[EMAIL PROTECTED]>
To: "ANdrei" <[EMAIL PROTECTED]>
Cc:
Sent: Monday, May 30, 2005 10:23 AM
Subject: Re: 802.11 card D-Link DWL-G520+ or TrendNet TEW 423-PI support
Hello ANdrei,
DWL-G520+ as i know don't supported by ath driver,
i have DWL-G520 without plus. As i know it device have
another chipset.
--
Best regards,
Andrey mailto:[EMAIL PROTECTED]
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hardware
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
