I am using a Promise SATA150TX4 SATA controller card (non-raid) on an
FreeBSD 5.4 system. I have two hard drives in hot-swap bays and cannot
successfully hot-swap the drives. I can unmount the drive, issue an ata
detach on the channel ("atacontrol detach 6"), pull the drive, and the drive
is no longer visable. I can then reinsert the drive, reattach the channel
("atacontrol attach 6"), remount the volume, and I can read the data on the
drive again. The problem is that whenever I do this, I will get a kernel
panic page fault several hours later. It only happens when I try to remove
the drive, and it always happens when I try to remove a drive. Am I doing
something wrong? Or is SATA not actually hot-swappable like it is
advertised as?
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hardware
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
