Yes, i will try today! Not sure how to though, but i will try :) ________________________________
From: John Baldwin [mailto:[EMAIL PROTECTED] Sent: Tue 1/3/2006 9:57 AM To: [email protected] Cc: Anton Zavrin Subject: Re: Hardware is compatible with FreeBSD 4.x but fails on FreeBSD 6.x On Saturday 31 December 2005 04:32 pm, Anton Zavrin wrote: > Hello, > > > > Can someone provide some input on such phenomena. > > > > I tried to install FreeBSD 6.0 on the same computer that is currently > running FreeBSD 4.10, but when I try to wipe existing harddrive clean it > says no HDDs found, also, advising me to check if my HDD controller is > supported or something in that spirit. > > > > This is from dmesg on that PC: > > atapci0: <VIA 8235 ATA133 controller> port 0xfc00-0xfc0f at device 17.1 > on pci0 > > ata0: at 0x1f0 irq 14 on atapci0 > > ata1: at 0x170 irq 15 on atapci0 > > > > I checked FreeBSD hardware notes for 6.0 and didn't see any references > for this controller. Does it mean I must change my motherboard to > install 6.0 or/and up? Is there anyway that you could capture the dmesg from the 6.0 boot perhaps using a serial console? -- John Baldwin <[EMAIL PROTECTED]> <>< http://www.FreeBSD.org/~jhb/ "Power Users Use the Power to Serve" = http://www.FreeBSD.org _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[EMAIL PROTECTED]"
