My plans are to get a new one. Unfurnately can't sell it, because it is built onto the board. I am currently working on picking a good one. Don't need RAID though, I plan to implement that using GEOM later on.
Any opinions on if I should worry about corruption with those occasional messages till then? On Thu, 5 Jan 2006 06:01:38 +0100 (CET) Heinz Suez <[EMAIL PROTECTED]> wrote: > Hi. I had the same problem a month ago with the same controller. > The problem was that i bought this pci sata controller with the > sil3112 for an old computer (dual p3 550, 512mb ram pc133, pci > 2.1), so the transfer rate & buffer was higher than the mother > board was able to deliver...in other words, the sata controller > (the sil3121 chipset i mean) was not 100% backwards compatible with > pci 2.1 when it should be. I tried this controller with a brand new > computer and worked just fine with lots of hdd's. Now, you have 2 > solutions: Sell the controller if it's a pci card or buy a more > expensive card with a different chipset. There're a lot of sata > chipsets that support pci 2.1 or older computers, i have seen lots > of users running sata raid at full speed on p2 machines. Good luck. > Vulpes Velox <[EMAIL PROTECTED]> escribió: I am getting entries > like this in dmesg. ad10: TIMEOUT - WRITE_DMA retrying (2 retries > left) LBA=355277839 ad10: TIMEOUT - WRITE_DMA retrying (2 retries > left) LBA=358666287 > > smartctl -t long /dev/ad10 shows it to be good though. The results > from the times I have run it show it completing successfully every > time. I believe I have no reason to suspect a bad disk and it just a > crappy chip. From what I have read in the mailing list archives, I > believe this to be true. Any one have any opinions otherwise on this > or the like? > > > The machine this is running on has releng_5 on it. > > I was wondering if any one had any suggestions on a good for a good > sata pci card that preferably has 4 connectors on it. > > > SiI 3112 sysctl entry if any one is curious. > dev.atapci.1.%desc: SiI 3112 SATA150 controller > dev.atapci.1.%driver: atapci > dev.atapci.1.%location: slot=11 function=0 > dev.atapci.1.%pnpinfo: vendor=0x1095 device=0x3112 subvendor=0x1095 > subdevice=0x6112 class=0x010400 dev.atapci.1.%parent: pci1 _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[EMAIL PROTECTED]"
