At 11:51 AM 3/10/2007, [EMAIL PROTECTED] wrote:
Do you know what the actual attached disk(s) are? Can you get into
the MPT BIOS and look at the RAID Properties tab if it exists?
Hi,
Yes, I just attached a couple of Segate SATA drives and configured
the card to be a RAID1 mirror.
---Mike
At 01:21 AM 3/10/2007, [EMAIL PROTECTED] wrote:
Haven't a clue- this doesn't appear to be the embedded mirroring
adapter- which is good because you're lucky if it works at all for
you. What's the actual underlying device?
Hi,
Not sure how to find that out ? I dont see anything in
dmesg or pciconf other than what I included in the original email.
---Mike
| LSI Logic MPT Setup Utility v6.04.00.00 (2005.08.29) |
| Adapter List Global Properties |
| Adapter PCI PCI PCI PCI FW Revision Status Boot |
| Bus Dev Fnc Slot Order |
| SAS1064 03 01 00 02 1.06.00.00-IR Enabled 0 |
[tyan-1u]% dmesg | grep mpt
mpt0: <LSILogic SAS/SATA Adapter> port 0xd800-0xd8ff mem
0xdfefc000-0xdfefffff,0xdfee0000-0xdfeeffff irq 48 at device 1.0 on pci3
mpt0: [GIANT-LOCKED]
mpt0: MPI Version=1.5.10.0
mpt0: mpt_cam_event: 0xb
mpt0: Unhandled Event Notify Frame. Event 0xb (ACK not required).
da0 at mpt0 bus 0 target 8 lun 0
[tyan-1u]% dmesg | grep da0
da0 at mpt0 bus 0 target 8 lun 0
da0: <LSILOGIC Logical Volume 3000> Fixed Direct Access SCSI-2 device
da0: 300.000MB/s transfers, Tagged Queueing Enabled
da0: 75340MB (154296320 512 byte sectors: 255H 63S/T 9604C)
[tyan-1u]%
[EMAIL PROTECTED]:1:0: class=0x010000 card=0x30201000 chip=0x00501000
rev=0x02 hdr=0x00
vendor = 'LSI Logic (Was: Symbios Logic, NCR)'
class = mass storage
subclass = SCSI
cap 01[50] = powerspec 2 supports D0 D1 D2 D3 current D0
cap 05[98] = MSI supports 1 message, 64 bit
cap 07[68] = PCI-X 64-bit supports 133MHz, 2048 burst read,
16 split transactions
cap 11[b0] = MSI-X supports 1 message in map 0x14
--------------------------------------------------------------------
Mike Tancsa, tel +1 519 651 3400
Sentex Communications, [EMAIL PROTECTED]
Providing Internet since 1994 www.sentex.net
Cambridge, Ontario Canada www.sentex.net/mike
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hardware
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
