Razor wrote:
The card works well in FreeBSD 7.0-RELEASE. After I upgrade to 8-CURRENT. The wlan0 can not associate with my AP. Here is my rc.conf and wpa_supplicant.confrc.conf: wlans_wi0=wlan0 ifconfig_wlan0="WPA DHCP" /etc/wpa_supplicant.conf: ctrl_interface=/var/run/wpa_supplicant network={ ssid="FreeBSD" scan_ssid=1 key_mgmt=NONE wep_tx_keyidx=0 wep_key0=ABCDEF01234567890ABCDEF012 } ifconfig wi0: wi0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 2290 ether 00:20:e0:8a:2d:88 media: IEEE 802.11 Wireless Ethernet autoselect mode 11b status: associated ifconfig wlan0: wlan0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500 ether 00:20:e0:8a:2d:88 media: IEEE 802.11 Wireless Ethernet autoselect (autoselect) status: no carrier ssid "" channel 10 (2457 Mhz 11b) country US authmode WPA1+WPA2/802.11i privacy ON deftxkey UNDEF txpower 0 bmiss 7 scanvalid 60 roaming MANUAL bintval 0
Intersil prism cards should work fine though they may require a firmware upgrade to ~rev 1.7. Unfortunately you've not shown the boot messages for the wi device so there's no way to tell what card you have.
Other devices that used to be supported by wi were broken in the vap conversion. Someone else will need to step up and fix the driver to support them; I have no time right now.
Sam _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[EMAIL PROTECTED]"
