>> Since this is the first instruction in section 31.5.1 from the >> handbook, this was the first command I typed. The module is already >> loaded. >> >> However >> >> # ls /dev/ubt* >> ls: No match. >> >> Should the device be recognized? What else should I try? >> > > usbconfig show_ifdrv >
% usbconfig show_ifdrv ugen0.1: <XHCI root HUB 0x8086> at usbus0, cfg=0 md=HOST spd=SUPER (5.0Gbps) pwr=SAVE (0mA) ugen0.1.0: uhub0: <0x8086 XHCI root HUB, class 9/0, rev 3.00/1.00, addr 1> ugen1.1: <EHCI root HUB Intel> at usbus1, cfg=0 md=HOST spd=HIGH (480Mbps) pwr=SAVE (0mA) ugen1.1.0: uhub1: <Intel EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> ugen2.1: <EHCI root HUB Intel> at usbus2, cfg=0 md=HOST spd=HIGH (480Mbps) pwr=SAVE (0mA) ugen2.1.0: uhub2: <Intel EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> ugen1.2: <product 0x0024 vendor 0x8087> at usbus1, cfg=0 md=HOST spd=HIGH (480Mbps) pwr=SAVE (0mA) ugen1.2.0: uhub3: <vendor 0x8087 product 0x0024, class 9/0, rev 2.00/0.00, addr 2> ugen2.2: <product 0x0024 vendor 0x8087> at usbus2, cfg=0 md=HOST spd=HIGH (480Mbps) pwr=SAVE (0mA) ugen2.2.0: uhub4: <vendor 0x8087 product 0x0024, class 9/0, rev 2.00/0.00, addr 2> ugen1.3: <USB2.0-CRW Generic> at usbus1, cfg=0 md=HOST spd=HIGH (480Mbps) pwr=ON (500mA) ugen1.4: <Bluetooth USB Host Controller Atheros Communications> at usbus1, cfg=0 md=HOST spd=FULL (12Mbps) pwr=O _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hardware To unsubscribe, send any mail to "[email protected]"
