On Tue, 14 Oct 2003, 14:50-0500, [EMAIL PROTECTED] wrote: > > I have three Squid machines working together as a cache array. > I used Dummynet to control the inter-cache bandwidth. > > My three squid is 10.12.0.1, 10.12.0.2 and 10.12.0.3 > > I used the following commands to create pipes in each squid > For example, in Squid1: > ipfw add pipe 1 IP from 10.12.0.1 to 10.12.0.2 out > ipfw add pipe 2 IP from 10.12.0.1 to 10.12.0.3 out > ipfw pipe 1 config bw 10Mbit/s queue 75Kbytes > ipfw pipe 2 config bw 10Mbit/s queue 75Kbytes > > I have another program to change the bandwidth of each pipe every half an > hour, with a lot of traffic going through the caches at the same time. So > that the configeration for a pipe can change > > FROM: ipfw pipe 1 config bw 10Mbit/s queue 73Kbytes > > TO: ipfw pipe 1 config bw 2Mbit/s queue 25Kbytes > > Then in very short time, the machine is dead. I think the problem might > because of the setting of "queue". But I don't know how much should be > correct. I was using "bw x Mbit/s queue 6*x+13 Kbytes". > > Oh, when bandwidth change from 5M to 3M ,or 8M to 5M (smaller difference), > the machines will run just fine with my 6*x+13 setting. Only steep jump > like from 8M to 2M will always cause death. > > Please help me out!!! This is emergency!!!!
... and uname -a says? _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"
